Concrete Floor Installation in Lodi CA - a slab built for what it will carry

Cracked, uneven or bare dirt where a floor should be? We pour a flat slab sized for its load and ready for what goes on top.

Most of a concrete floor is work you won't see once it's poured, the digging, the packed base and the square forms. We get that part right first, then pour and finish a slab flat enough for whatever goes on it.

Curved gray paver patio with rounded tan steps leading to a home and a circular fire pit.
  • Fully licensed and insured.
  • Free in-person estimates.
  • Expect a reply within 1 business day.

A floor that's flat, square and ready

  • The owner on site

    I come out and measure your job myself, and I'm on site with our crew when we set forms and pour.

  • Covered from forms to finish

    We're fully licensed and insured, so the crew working at your house is covered while the job is open.

What goes into a new concrete floor in Lodi?

Concrete floor installation in Lodi is forming, pouring and finishing a flat slab for a garage, shop, addition or outbuilding, usually with rebar or wire mesh, the steel set inside to hold the concrete together. One Call Lodi Concrete Company is based in Lodi and works in the cities around it in San Joaquin and Sacramento counties. Your price mostly turns on the floor's size, how thick it has to be for what it carries, how much digging and base work the ground needs, and whether flooring or a coating calls for a barrier underneath. The schedule turns on that prep and on the weather, because heat, dry air and wind pull water out of fresh concrete too fast, mostly in summer, and then on the wait before you can use the floor. I'll measure your site and walk you through the options at the estimate. The state licensing board puts this kind of flat concrete work under its C-8 concrete contractor class, so ask anyone who bids your floor which license they hold.

Concrete floor installation options in Lodi

  • Garage, shop and shed floors

    Garage slabs sit at the thicker end of the usual home range, and so do floors under heavy vehicles or a shed. Tell me what's parking, rolling or sitting on it, so we size the slab for that load instead of guessing.

    Schedule an estimate
  • Floors that get tile, wood or a coating

    If flooring or an epoxy coating is going over the slab, we settle the moisture barrier underneath first, because it's hard to fix once the floor is down. The questions below cover what that barrier should be and where it sits.

    Schedule an estimate
  • Floors for additions and new rooms

    A floor for an addition has to meet the house at the right height and carry walls as well as people. Foundation slabs sit at the thicker end of the range too, and our slab foundation building page covers that side of the work.

    Schedule an estimate
  • Floors that meet a door or step

    Where a new floor meets an outside door, we set its height and the slab beyond it so water runs away from the house. If you're also adding concrete steps or a concrete pool deck, it's easier to plan the heights together.

    Schedule an estimate

How do you know it's time for a new concrete floor?

  • Cracks that keep growing

    Hairline cracks are normal, but cracks that keep widening or have one side higher than the other usually mean the base underneath moved.

  • A floor that's sunk or tilted

    If a ball rolls to one corner or gaps open along the bottom of the walls, the dirt under the slab likely settled because it wasn't packed.

  • Flooring lifting or damp spots

    Tile popping loose, vinyl bubbling or dark damp patches on bare concrete often point to ground moisture coming up through a slab with no good barrier.

  • A dusty, flaking top

    If the surface keeps shedding powder or chipping under a broom, it may have dried too fast on pour day and stayed weak on top.

How a concrete floor installation job runs

  1. You call or send a request

    • Call (209) 280-3061 or use the form
    • Give the floor's rough size
    • Say what it will carry
    • Mention flooring or coating plans
  2. I come out and measure

    • I measure the space and the ground
    • I check where water runs
    • We talk through your options
    • We go over the estimate together
  3. Base, forms and the pour

    • We dig out and pack the base
    • Moisture barrier down when flooring's planned
    • Forms, grades and joints checked first
    • Then the truck comes and we pour
  4. Walk-through and first use

    • We walk the finished floor together
    • We show you where joints run
    • We go over curing and first use
    • We clean up before we leave

Ask for a free concrete floor estimate

Send the floor's size, what it will carry and any flooring or coating plans. We'll reply within one business day, and I'll set a time to come measure, with no obligation.

Concrete floor questions from Lodi

Here are plain answers to what homeowners ask before a floor goes in. If yours isn't here, call (209) 280-3061.

What does a concrete floor cost near Lodi?

A concrete slab in the Stockton area usually costs about $7 to $14 per square foot, not counting staining or stamping. Reinforced slabs cost more per square foot than plain pads. For a Lodi price on your floor, I'll measure it and go over the numbers at the estimate.

Will my new concrete floor crack?

Yes, some tight cracks, and industry floor guidance says some random cracking should always be expected. Rebar or mesh won't stop it, but placed right it keeps cracks tightly closed. We saw control joints, grooves that give shrinkage cracks a line to follow, within hours of the pour.

How soon can I walk on a new concrete floor or park on it?

You can usually walk on a new slab within 48 hours, but concrete takes 28 to 30 days to fully cure, the slow hardening that gives it strength. To be safe, give it about a week before parking on it or moving anything heavy in.

What goes under a concrete slab floor?

A packed base, plus a vapor barrier, a sheet that keeps ground moisture out, when flooring or a coating is planned. Industry floor guidance says the barrier protects coverings best laid right against the slab and that plain polyethylene sheeting shouldn't be counted on, so ask what sheet goes under yours.

Why does base prep matter so much for a concrete floor?

Because a slab only stays flat if the subgrade, the dirt it sits on, is dug out and packed instead of raked level. Nobody sees the base once it's poured, so it's the first thing that gets cut from a budget, and it's the last place I'd cut.

Who handles building plan checks and inspections in Lodi?

The city's Building Division does, guiding contractors and property owners through plan check and inspection under California building code. For house foundation slabs, it also lists a slab addendum tied to a soil engineer's report. We look into what the city or county asks for on your job and help with the paperwork before work starts.

Other concrete work we do

  • Service

    Concrete steps construction

    When your new floor sits higher than the yard or garage, steps poured with it land at the right height and stay square to the door.

    Read more Concrete steps construction
  • Service

    Concrete pool decks

    If the new room or floor opens onto a pool, a deck planned with it keeps the heights matched and the water running away from the house.

    Read more Concrete pool decks
  • Service

    Garage floor concrete

    For a garage, the floor has to carry cars and drain toward the door, so that page covers the thicker slab and slope a garage needs.

    Read more Garage floor concrete

Get a free estimate on your floor

Request an estimate

Concrete floors in Lodi and nearby cities

We're based in Lodi and pour floors in Stockton, Galt and the cities around them. Pick your area below, or call if yours isn't listed.

Call (209) 280-3061